There are some small problems rising by electric windows. These problems seem to be small, but they cannot be underestimated, because electric windows are also one of the more faults on the car.

Common faults are:

The windows cannot rise or fall; the window glass falls down; the windows are difficult or noise.

There are many reasons for these failures, and the common ones are:

Control switch failures, motor failures, windows lifting mechanism failures, glass bracket failures and other problems.

In order to reduce the failure caused by electric windows, the correct use and maintenance method is a skill that every car lovers must master.

There are noise during lifting, what is the reason?

A: The windows of the windows are constantly lifting, and the phenomenon of aging of rubber guidance is prone to occur. When the glass of the car is raised for a long time, there will be a slight stuttering phenomenon.

After this situation, you can use the window to lubricate oil. It is very important to apply a maintenance agent to rubber. Among them, the rubber part that supports both glass needs to be carefully checked whether it is good. The sliding condition of the glass and the guide slot can be applied when the sliding condition of the guide slot can be applied.

B: Another situation is that there are abnormal noises due to dust gathered in the window rubber guide groove in the window rubber groove, and the rising resistance of the window has increased. At this time, as long as the glass guide slot is cleaned.

method:

Turn off all the windows, spray the instrument in the car, and spray wax oil along the side of the guide slot, including the position that is touched when the glass is liter, and try to spray it as much as possible. Then, the glass is lifted several times, and then sprayed, so that the glass rubbed with wax oil and the guide slot, and then brought out the dirt. Then use cotton or soft cloth to wipe the inside surface of the guide slot and clean up the dirt. The focus is on the outside of the window, because most dirt is brought from the outside with the rain.

C: The unsatisfactory action of the window switch is also related to the window gear, so the window gear must be injected regularly.

Before we cheer for the internal mechanical device, the first step is to remove the cup lid, remove the plastic paper used below, and remove the screws inside, and finally remove the fast switch of the window. It is to spray fat inside the window gear. At this time, what we have to do is to spray the windows on the upper and lower windows, so that each part can be applied to the oil.

After the glass water is used, can it be replaced by tap water?

Some people have no glass water, and they choose to use washing powder or detergent to replace glass water by themselves, or use water directly. These methods are not desirable.

There are some sediments in chemical detergents such as washing powder. It is easy to corrode the rubber tube for a long time, and it will block the water spray mouth. In severe cases, it will damage the motor.

The general detergent will also constantly corrode the rubber tube to accelerate the hardening of the tubing tape. When the hardening glue strip scrape the windshield, the surface of the windshield will be scratched and scraped. If the wiper is replaced, the cost will be dozens of times the glass water.

Although the ordinary water is clean, there are many chemical residues inside, and the accumulation will also cause the blocked water outlet and affect the water spray.

If it is used for a long time, it will also increase the friction of the mirror surface, leaving a slight scratch to the mirror surface when the wiper is cleaned.

method:

Recommended quality window regulators: window regulator with motor.