As the title says, there are many fast charging lines on the market at present, cheap power can not reach, good and expensive, and the joint is easy to break after a long time

Today I will hand you over how to make a 100w fast charging line by yourself,

Tool preparation: soldering iron, tin wire, hot melt gun, flux.

Material preparation: 8-core braided wire, 8-core type-c plug set, plug shell 2pcs, 704N glue. (Accessories can go to a treasure to buy by yourself)

I use braided thread, and I think the braided thread is durable and looks better. It is hard relative to the silicone line.

The following figure is an 8-core wire welding diagram, which can be connected according to the drawing.

I feel finished, because the rosin I use is not as good as flux, and in the comparison of welding, you can clearly see that the solder joints are pointed [cover face] [cover face]

Can it be charged under the wiring test after wiring (because I forgot to take a picture of Type-C, the figure below is the Apple 20W fast charge test)

You can see that the iPhone X I use can reach 20w charging, (test software name: charging assistant, Android phone can use amperp)

At the same time, dual type-C can also charge Huawei notebooks, the picture below shows Huawei’s original 20v3.25A charging head with its own cable. The voltage is 19.69V,

In the end, the glue screwed on the plug shell did not shoot a person is not good to operate.

Finally, let’s enjoy the finished product

Summary: The material consumption is about 50 (due to the lack of professional test equipment, all test data are physical test results). Much cheaper than a certain treasure finished product. You can also have fun doing it yourself.

High-quality product recommendation: Silicone wire.